
Using DISKCOPY with two diskette drives
1. Make sure the diskette you want to copy is write-protected.
(See Chapter 3 for instructions.)
2. If you don’t have a hard disk, insert your Working 1
(5
or Startup (3
diskette into drive A.
3. At the MS-DOS command prompt, type the following and
press
Enter:
DISKCOPY
MS-DOS prompts you to insert your diskettes:
Insert SOURCE diskette in drive A:
Insert TARGET diskette in drive B:
Press any key to continue . . .
4. Remove the diskette in drive A, if necessary, and insert the
diskette you want to copy from (the source diskette) into
drive A and the diskette you want to copy to (the target
diskette) into drive B. Then press any key to begin copying.
If the target diskette is not formatted, DISKCOPY formats
it before copying data to it.
5. When the copy is complete, you see this message:
Press Y and
Enter
to copy another diskette or
N
and
Enter
to return to the MS-DOS command prompt.
Using DISKCOPY with one diskette drive
1. Make sure the diskette you want to copy is write-protected.
(See Chapter 3 for instructions.)
4-34
Using MS-DOS with Your Equity IIe
Summary of Contents for Equity IIe
