Epson ACULASER COLOR 1000, Service Manual

Page: 53 / 230

EPSON AcuLaser C2000 / AcuLaser C1000 Revision E
Product Descriptions Control Panel (AcuLaser C1000) 53
1.5 Control Panel (AcuLaser C1000)
1.5.1 Exterior View and Names (AcuLaser C100)
1.5.2 Meanings of LEDs (AcuLaser C100)
*1: “Flash 1" repeats a cycle of on for 0.3 sec and off for 0.3 sec.
*2: “Flash 3" repeats a cycle of on for 0.6 sec and off for 2.4 sec.
NOTE: After power on, the two LEDs will light up and about 1.5 seconds
later they will go out.
During RAM Check, Ready LED will indicate “flash 1" (cycles of on
for 0.3 sec and off for 0.3 sec.)
Table 1-32. Control Panel Description
Name Remarks
1 Ready LED Color: Green
2 Error LED Color: Red
Table 1-33. Meaning of LEDs
Ready lED
(green)
Error LED
(red)
Supplement Meaning
Off Off - Power off
Off On -
Controller fatal errors
Video error
Data expansion error
Standard RAM check error
EEPROM access error
Software error
2
1
Flash 1 * 1 Off -
Warming up, and data receiving,
Reset, Calibrating Printer, Cooling
Down
Flash 3 *
2
Off - Warning of consumables (6 kinds)
Flash 1 *
1
Flash 1
Green and red LED
flash alternately
Engine error
Flash 1 * 1 On - Protocol error
On Off -
Ready to print, Printing Job,
Standby, Warning (other than
consumables)
On Flash 1 -
Recoverable errors
Check Media Type
Install Consumables (6 kinds)
Clean Sensor
Replace Consumables (6 kinds)
Paper Set
Invalid Size
Underrun Error
Mem Overflow
Duplex Mem Overflow
Invalid AUX I/F Card
On On -
Paper Out, Paper Jam, Duplex P-
Size Error, Cover Open (3 kinds)
Table 1-33. Meaning of LEDs (continued)
Ready lED
(green)
Error LED
(red)
Supplement Meaning