Epson ACULASER COLOR 1000, Service Manual

Page: 122 / 230

EPSON AcuLaser C2000 / AcuLaser C1000 Revision E
Troubleshooting Printer Message 122
Remedy: Clicking the [Close] button will close the pop-up display of
the EPSON Status Monitor. However, if an error of higher
priority occurs just after that, the display changes to the
error display. From this point, the printer will follow the
error recovery procedure, and the status will never go
back to the “Image Optimum” warning.
†
Can't print duplex
Description: Since duplex printing was impossible due to restrictions on
duplex printing, simplex printing was performed.
Due to the fact that the printer does not transpose the
pages of sent data, simplex printing proceeds in the order
of the back page first and then the front page.
The printer is released from this warning by the ResetFlag
command of the ESCPAGES-02 protocol.
This status is the “Can't print duplex” error in ESC/Page
models. However, since this status can not occur in
normal operations, it is changed to a warning.
Remedy: Clicking the [Close] button will close the pop-up display of
the EPSON Status Monitor. However, if an error of higher
priority occurs just after that, the display changes to the
error display. From this point, the printer will follow the
error recovery procedure, and the status will never go
back to the “Can't print duplex” warning.
Due to restrictions checked by the driver, this error can not
occur practically.
†
Print Failure
Description: Although an error equivalent to the “Invalid Size”, “Mem
Overflow” or “Duplex Mem Overflow” has occurred,
printing has been continued displaying this warning, since
“Avoid Error = ON” has been set.
In any EPSON printers other than host based, the relevant
one of these three messages will be displayed about 5
seconds and then cleared automatically if “Avoid Error =
ON”. But with a host based printer, Status Monitor cannot
monitor these messages, so the error message will be
cleared immediately and status monitor will display this
Warning message.
Remedy: Clicking the [Close] button will close the pop-up display of
the EPSON Status Monitor. However, if an error of higher
priority occurs just after that, the display changes to the
error display. From this point, the printer will follow the
error recovery procedure, and the status will never go
back to the “Print Failure” warning.
†
Need Memory
Description: Printing was performed by a flying start as a result of
buffer-full status. However, if sufficient memory is not
available for printing, the “Print Underrun” error occurs.
This status does not occur in printing via a network
connection where a flying start is not applicable.The print
result will be at the same level in quality as with sufficient
memory.
Remedy: Clicking the [Close] button will close the pop-up display of
the EPSON Status Monitor. However, if an error of higher
priority occurs just after that, the display changes to the
error display. From this point, the printer will follow the
error recovery procedure, and the status will never go
back to the “Need Memory” warning.
†
Screen Mismatch
Description: Since color screen adjustment for printing image does not
match the printer internal color screen, printing has
continued displaying this warning.
Remedy: This warning will occur when the screen matching
between driver and printer is not achieved.
Clicking the [Close] button will close the pop-up display of
the EPSON Status Monitor. However, if an error of higher
priority occurs just after that, the display changes to the
error display. From this point, the printer will follow the
error recovery procedure, and the status will never go
back to the “Screen Mismatch” warning.