Epson ACULASER COLOR 1000, Service Manual

Page: 119 / 230

EPSON AcuLaser C2000 / AcuLaser C1000 Revision E
Troubleshooting Printer Message 119
†
Duplex Mem Overflow
Description: Data for the front page (the second page of duplex) was
not saved due to an insufficient memory. The Continue
command of the ESCPAGES-02 protocol releases the
printer from the error, and printing resumes from the next
combination of the front and back pages. When “Avoid
Error = ON” is set, the printer displays the “Print Failure”
error status instead of this error, and resumes printing the
next combination of the front and back pages.
Remedy: To print pages subsequent to the occurrence of “Mem
Overflow”, select [Continue] in the EPSON Status Monitor.
When driver settings are to be changed for reprinting,
select [Cancel Printing] in the EPSON Status Monitor.
†
Invalid AUX I/F Card
Description: An interface card that cannot be used is installed.
Since the printer checks an interface card only when it is
turned on, the printer does not recover from this error
while the power to the printer is on.
Only interface cards compatible with expansion of
background job commands are supported.
Even if this error has occurred, the following operation is
possible.
• Display this status in EPW!
• Type B firmware update
Remedy: Turn off the printer, remove an invalid interface card, and
turn power on again.
3.2.4 Details of Warning Messages and Remedies
This section provides the details of warning messages and remedies that are
specific to AcuLaser C2000 / AcuLaser C1000.
3.2.4.1 Details of Warning Messages and Remedy
(AcuLaser C2000)
†
uuuu Toner Low
„
Explanation
This notifies the user of the warning message that the remaining toner
of each color (Y, M, C, K) is low. The remaining toner value for each
color is calculated from the engine’s remaining toner sensor (actually,
the dispensing time), and this message is displayed with the remaining
toner is approximately 80%. u u u u indicates CMYK, which correspond
to the C, M, Y and K toner cartridges, and out of these, the toner
cartridges only where it is detected that the remaining toner is low are
displayed.
„
Treatment Method
Display of this message is canceled by any one of the following.
1) Press the Continue switch.
2) Reset the printer.
3) Replace the Toner Cartridge indicated by the message with a new
one.