MP500/4N-8-16 Programming
85
6) The keypad will beep. Press
to exit without disarming. After 5 seconds, the status LED will switch
off and the squares will become empty indicating that the partitions have been disarmed. The following
will appear on the display:
7) Press
again if you do not want to wait for 5 seconds.
8) The display will go back to standard view automatically after one minute. Press
to go to standard
view immediately.
5.8.3
Partial disarming (system with partitions only)
Proceed as follows to arm the entire alarm system partially if no areas are defined:
1) Enter
<Master / User / Installer / Technical Manager code >
and press
.
2) The keypad will beep. Press
to exit without disarming. The following will appear on the display:
3) Enter the number of the partitions to be disarmed on the keypad: the respective squares will become
empty.
4) After 5 seconds, the LED will switch off and the squares will become empty indicating that the
partitions have been disarmed. The following will appear on the display:
5) The display will go back to standard view automatically after one minute. Press
to go to standard
view immediately.
IMPORTANT!
The user will disarm only the assigned partitions and not necessarily all the
partitions even with this procedure.
IMPORTANT!
Simply enter the number directly if nine or fewer partitions have been programmed.
If more than nine partitions have been programmed, always enter two digits to select the partitions,
including for numbers from 1 to 9 (1 = 01, 2 = 02 etc.).
EXECUTED
EXECUTED
DISARM
Summary of Contents for MP500/16
Page 139: ...MP500 4N 8 16 Programming 139 ...
