Elkron MP500/16, Programming Manual, Page: 70 / 140

70 MP500/4N-8-16 Programming
15) Repeat from step 11 for the other commands of the day, if needed .
16) Repeat from step 10 to configure the other day types.
17) Press .
18) Press .
19) Press and to select the warning time. Press to confirm.
20) Press repeatedly to exit from the menu.
4.19.3
Deleting a command
To delete a command, follow the programming procedure and select "NO ACTION" for the command.
To block the entire programming, disable it without deleting it (see
User Manual ).
4.20 SYSTEM TEST
Check correct operation of the system as a whole after having installed and configured the devices.
The main tests are:

Input test

Output test

Control panel battery test

Vocal call test

Alarm receiving centre test (if present)

GSM test (if present)

Radio device test (For more information see dedicated manual)

Environmental listening test
4.20.1
Input test
Proceed as follows to test that the inputs work perfectly:
1) Enter < Master / Installer code > , press and then .
2) Press repeatedly until TEST appears.
3) Press .
4) Press .
5) Trip all system detectors (e.g. by passing in front of the volumetric detectors and opening doors
with magnetic contacts). The input LED on the keypad will be activated whenever a detector is
activated. Press at the end.
6) Press .
7) Press to view the list of all the inputs which were tripped during the test.
8) Press and then .
9) Press to view the list of all inputs which did not change. The list should be empty if all inputs
were tripped during the test and they all opened and closed again correctly. Otherwise, the list will
contain the inputs which were either not tripped or did not respond correctly.
10) Press repeatedly to exit from the menu.
P.O.
COMMANDS TYPE
P.O.
WARNING TIME
WARNING TIME
WARNING 10m
UT00:INSTALLER
TEST
UT01:MASTER
TEST
TEST
TEST INPUTS
TEST INPUTS
IN PROGRESS...
TEST INPUTS
TEST RESULT
TEST RESULT
TEST INPUT OK
TEST RESULT
TEST INPUT KO