MP500/4N-8-16 Programming
53
4.18.2.1
How to play and record vocal messages
IMPORTANT!
On MP500/4N, MP500/8 and MP500/16 control panels, use a vocal keypad (KP500DV/N) or headset with
microphone to be plugged into the vocal synthesis board directly (installer only) to play and record vocal messages.
It is advisable not to hold the KP500DV/N keypad in your hand for better audio quality.
On SV500N boards, you can select to record using the headset with microphone or vocal keypad and setting the jumper
B
on the vocal
synthesis board appropriately.
Recording using
vocal keypad.
Recording using headset
plugged into jack
A
.
Figure 8 - Vocal synthesis board jumper and jack
4.18.2.2
Vocal message configuration
Proceed as follows to configure the vocal messages:
1) Enter
<Master / Installer code>
, press
, then
and finally
repeatedly until TELEPHONE
DIALER appears.
2) Press
and then
.
3) Press
.
4) Press
.
5) Press
and
to select the desired message. Press
to confirm.
6) Press
and
to select whether to play or record the message. Press
to confirm. The
maximum length of a message is 4 seconds. The message “RECORDING IN PROGRESS...”
appears once the recording has started. The recording will stop automatically after the maximum
time (which cannot be shortened).
IMPORTANT!
The original messages will be lost and can no longer be restored after they
have been written over.
7) Press
to configure the other vocal messages repeating the procedure from step 5.
IMPORTANT!
The basic message is the only one which must always be recorded during
the first installation.
8) Press
repeatedly to exit from the menu.
UT00:INSTALLER
TELEPHONE DIALER
TELEPHONE DIALER
VOCAL MESSAGES
VOCAL MESSAGES
MESSAGE LIST
MESSAGE LIST
BASE MESSAGE
BASE MESSAGE
PLAY
Summary of Contents for MP500/16
Page 139: ...MP500 4N 8 16 Programming 139 ...
