80
MP500/4N-8-16 Programming
5.4.4.2
System in use mode = Mode 2 or Mode 0
Proceed as follows to arm only the partitions assigned to the reader and to the key using the electronic key:
1. Insert the electronic key in the reader when all the green LEDs are off (the procedure will arm the partitions if any LEDs are green
during the first cycle). The red LED will blink to indicate that the key is being read. All the green LEDs will blink rapidly if the key is
not recognised.
2. The red LED will blink and after a few seconds a cycle will start during which the green LEDs blink for a few seconds showing the
various combinations in sequence.
3. Extract the electronic key when the combination of partitions to be armed is displayed by the LEDs. The possibility of arming each
partition depends on the programming of the reader and on the key used.
4. The green LEDs indicate the status of the partitions assigned to the reader.
LED on fixed
= partition(s) armed,
LED off
= partition
disarmed.
IMPORTANT!
The key will arm only the assigned partitions and not necessarily all the partitions even with this procedure.
5.4.5
Partial arming from proximity key reader
5.4.5.1
System in use mode = Mode 3 (EN50131 grade 3 compliant)
Proceed as follows to arm only the partitions assigned to the reader and to the key using the proximity key:
1. Approach the proximity key to the transponder. The red LED will blink to indicate that the key is being read and the green LED will
light up after a few instants to indicate that the key was recognised. All the green LEDs will blink rapidly if the key is not recognised.
2. The green LEDs corresponding to the armed partitions, if any, will appear if the key is recognised. The red LED will keep blinking.
3. Move the proximity key away.
4. Approach the proximity key again when the red LED switches off.
5. The red LED will blink and after a few seconds a cycle will start during which the green LEDs blink for a few seconds showing the
various combinations of partitions in sequence.
6. Move the proximity key away when the combination of partitions to be armed is displayed by the LEDs. The possibility of arming
each partition depends on the programming of the reader and on the key used.
7. The chosen partitions will be armed and the green LEDs will indicate the status of the partitions assigned to the reader for a few
seconds.
IMPORTANT!
The key will arm only the assigned partitions and not necessarily all the partitions even with this procedure.
5.4.5.2
System in use mode = Mode 2
Proceed as follows to arm only the partitions assigned to the reader and to the key using the proximity key:
1. Approach the proximity key to the transponder and hold it close for at least three seconds. The red LED will blink to indicate that the
key is being read. Move it away when the four green LEDs blink.
2. A cycle will be started during which the green LEDs blink for a few seconds showing the various combinations in sequence. The
possibility of arming each partition depends on the programming of the reader and on the key used.
3. When the combination of partitions to be armed is displayed by the LEDs, approach the proximity key to the transponder again, wait
for an instant and then move it away.
4. The green LEDs will indicate the status of the partitions assigned to the reader for a few seconds:
LED on fixed
= partition(s)
armed,
LED off
= partition disarmed.
IMPORTANT!
The key will arm only the assigned partitions and not necessarily all the partitions even with this procedure.
Summary of Contents for MP500/16
Page 139: ...MP500 4N 8 16 Programming 139 ...
