84
MP500/4N-8-16 Programming
5.7.5
Disarming from keypad under hol-up
On MP500/4N, MP500/8 and MP500/16 control panels, starting from control panel SW version 1.01, if the hold-up function has been
enabled (see paragraph 2.1.4
How to enable the hold-up function
) and you are threatened and forced by a criminal with the risk of life
then, you can disarm the burglar system while arming the hold-up alarm simultaneously which will make the dialer sending the
programmed alarm messages without activating the siren sound.
To disarm the system when your are under coercion, just increase your user code of one digit. For example if your user code is 000021
you need only to enter 000022; if user code is 29 enter 30, if it is 39 enter 40, etc.
IMPORTANT!
Enabling the hold-up function will cancel EN50131 compliance.
5.8
DISARMING FROM KP500DP/N - KP500D/ST KEYPAD
5.8.1
Total disarming (system with partitions only)
Proceed as follows to disarm the entire alarm system if no areas are defined:
1) Enter
<Master / User / Installer / Technical Manager code >
and press
.
2) The keypad will beep. Press
to exit without disarming. After 5 seconds, the status LED will switch
off and the squares will become empty indicating that the partitions have been disarmed. The following
will appear on the display:
3) Press
again if you do not want to wait for 5 seconds.
4) The display will go back to standard view automatically after one minute. Press
to go to
standard view immediately.
5.8.2
Total disarming (system with areas and partitions)
Proceed as follows to arm the entire alarm system if areas are defined:
1) Enter
<Master / User / Installer / Technical Manager code >
and press
.
2) Press
F1
for areas or
F4
for partitions. Press
F1
(i.e. areas) on the display. An empty square will
appear for each programmed area which is not armed assigned to the keypad and code. Full squares
indicate that the area is armed. Half-full squares indicate that the area is only partially armed.
3) The keypad will beep. Press
to exit without disarming. After 5 seconds, the status LED will switch
off and the squares will become empty indicating that the areas have been disarmed. Any half-full
squares indicate that the area is partially armed. The following will appear on the display:
4) Press
if you do not want to wait for 5 seconds.
IMPORTANT!
The user will disarm only the assigned areas and not necessarily all the areas even
with this procedure.
5) If
F4
(i.e. partitions) was pressed instead, the following will appear on the display:
EXECUTED
DISARM
DISARM
DISARM
EXECUTED
DISARM
AREAS
PART
Summary of Contents for MP500/16
Page 139: ...MP500 4N 8 16 Programming 139 ...
