25
Installation Manual
Mounting System
25mm (1")
(four locations
underneath
the inverter)
25mm
(1") (one
on each
side)
50mm (2.0") (two
locations, one on each
side of the 5 kWh
battery enclosure)
50mm (2.0") (multiple
locations on the sides of
the battery enclosure)
25mm (1") on top
and bottom of Auto-
Transformer
If needed, use a Greenlee Knockout Punch to create a punch
that will work for your installation.
Please note that all measurements below are for conduit fittings.
Ensure no
conduit
50mm (2")
between
inverter
and auto-
transformer
top and
bottom and
50mm (2”)
from wall
service
Observe clearances in section, “CLEARANCES & KNOCKOUT LOCATIONS” for
adequate cooling and maintenance. No conduit must be placed within 2" of the
wall's surface of the inverter’s or auto-transformer’s top and bottom to allow for
adequate cooling of the equipment's rear cooling fins.
