SV-D700, SV-D1000 and SV-D1000T Operation
SkyView Classic Pilot’s User Guide –
Revision Z
3-10
may not be able to remove some or all of the pages on a display. Additionally, the
LAYOUT and SWAP buttons may not be available.
Selecting and Arranging Pages on your SkyView Screen
1.
Press SCREEN on the Main Menu.
2.
Press PFD PG, EMS PG, or MAP PG to toggle the display of page on or off.
a.
Alternately, press and hold any of the above buttons for a few seconds to turn on
that page and turn all others off with just one button push.
3.
Press LAYOUT to toggle between different layouts of the pages that are being displayed.
4.
Press BACK to finalize the layout and return to the Main Menu.
Swap Mode
You may, at times, wish to swap the entire screen contents of your left and right displays
without having to select and deselect each page on each display using the above process. This
can be useful for flying from the “other” seat, for use when flight instructing, e
tc.
Press SCREEN > SWAP on either display to enter swap mode and switch the screen contents of
both displays simultaneously. When your screens are in swap mode, the PFD PAGE, EMS PAGE
MAP PAGE, and LAYOUT buttons are unavailable. Press SWAP again to exit swap mode and
revert to normal display operation.
Note that the SWAP button is only shown on SkyView systems that contain exactly two displays.
Reversion Mode
In multi-display SkyView systems, you can specify a reversion mode that automatically changes
the screen configuration to a specific layout when only one display remains powered on.
For example, if you normally have your left display configured to show PFD and your right
display showing Engine and Map, reversion mode could be configured to show all three pages
automatically on the single remaining display, should the other fail.
If reversion mode is enabled, any one of the following layouts can be pre-configured (via
SkyView setup procedures) to be displayed when only one display remains powered on in a
multi-display system. This behavior applies equally whether all but one display in your system
has failed, or if you turn on one SkyView display before all others (as some customers do to see
engine instruments before engine start):
•
PFD 40% / EMS / MAP 40%.
•
PFD 50% / MAP 50%.
•
PFD 50% / EMS 50%.
•
PFD 80% / EMS 20%.
•
PFD 100%.
