Dynapac CC950, Instruction Manual

Page: 139 / 143

Maintenance - 2000h
4812164101_A.pdf 2022-02-09
Hydraulic reservoir - fluid change
Use an external drainage pump when
draining/emptying the hydraulic reservoir.
Fig. Hydraulic reservoir
1. Draining
1
Danger of being burned when draining hot oil.
Use the following protective equipment: Danger of being burned when draining hot oil.
Use the following protective equipment:
Protective gloves Protective gloves
Safety glasses Safety glasses
Unscrew the tank cap. Place the pump's suction hose
in the filler/drain outlet in the hydraulic tank. Place the
other hose in a container.
Use a receptacle that holds at least
15 liters (4 gal). Use a receptacle that holds at least
15 liters (4 gal).
Collect the oil and deliver to environmentally
correct handling. Collect the oil and deliver to environmentally
correct handling.
Start the pump so that it sucks out the fluid from
the tank.
Check that the hose to the pump reaches the bottom
of the hydraulic reservoir to ensure that as much of the
fluid as possible is drained.
Change the hydraulic fluid filter, see under heading
'Every 1000 hours of operation'.
Fill up with the recommended hydraulic fluid to the
correct level. Replace the cap on the tank and wipe
clean.
Wipe up any spillage.
Start the engine and operate the various hydraulic
functions. Check the level in the reservoir and top off
as required.
129