Dynapac CC950, Instruction Manual

Page: 100 / 143

Maintenance - 50h
4812164101_A.pdf 2022-02-09
Engine oil and oil filter - Change
Fig. Oil drain plug
Do not drain oil after running the engine.
Allow engine to cool down sufficiently. Do not drain oil after running the engine.
Allow engine to cool down sufficiently.
Switch off the engine and remove the key. Switch off the engine and remove the key.
Take great care when draining fluids and oils. Use
the following protective equipment: Take great care when draining fluids and oils. Use
the following protective equipment:
Protective gloves Protective gloves
Safety glasses Safety glasses
Remove the drain plug (1) at the bottom of the engine,
and drain all the old oil.
Drain oil easier and completely while the engine is hot.
Add new engine oil up to the uppe limit of the oil level
gauge.
Replace the oil filter cartridge (2).
2
Fig. Oil filter cartridge
Remove the old oil filter cartridge with a filter wrench.
Apply a film of oil to the gasket for the new cartridge.
Screw in the cartridge by hand. When the gasket
contacts the seal surface, tighten the cartridge enough
by hand.
After the new cartridge has been replaced, the engine
oil level normally decreases a little.
Run the engine for a while and check oil leaks through
the seal before checking the engine oil level. Add oil if
necessary.
Dispose of the old filter carefully. Dispose of the old filter carefully.
90