DURKOPP ADLER 540-100-1, Manual Complete, Page: 179 / 234

5.6 Mounting the control unit
–
Mount the control unit (DAC III) onto the table plate using 4 wood
screws according to figure 2 on page 10. The side with the bushes
for the motors (three bushes, one under the other) has to point to
the right side.
5.7 Mounting the waste container
–
Remove cover 1 of the waste container.
–
Take the filter fleece 2 out of cover 1.
–
Screw cover 1 onto the table plate with two wood screws.
–
Refit the filter fleece 2 into the cover 1.
–
Refit the fleece clamping plate.
–
Finally stick the container 4 onto the cover 1.
5.8 Mounting the maintenance unit and the set value initiator
–
Screw plate 5 onto the set value initiator 6.
–
Screw the set value initiator plate 6 to the maintenance unit
L-bracket 7 on the cross strut of the frame 8 according to figure 4.
5.9 Mounting the pedal and the traction rod
–
Screw pedal 9 onto the frame strut 10.
For ergonomic reasons the pedal center should be directly under
the needle.
–
Fasten the traction rod 11 to the set value initiator 12 and the
pedal 9.
–
Loosen screw 13 on the traction rod 11.
–
Set the length of the traction rod 11 so that pedal 9, without any
pressure on it, has an inclination of about 10°.
–
Tighten screw 13 again.
15
2
1
2
3
4
9
10
12 13 11
6
5
7
8