DURKOPP ADLER 540-100-1, Manual Complete

Page: 138 / 234

4.3 Main menu
Symbol Parameter Meaning
Buttonhole number
N1 Selection of the buttonhole to be sewn
- Program number 1 to 50 contains
buttonhole programs. Program number 51
and 52 contain free contour sewing
programs.
- The preprogrammed form of the chosen
buttonhole is shown in the left half of the
display.
- Additionally an info window is shown with
some buttonhole specific values:
- Cut length
- Intermediate fabric
- Buttonhole seam stitch length
- Buttonhole width
Thread tension
N2 Selection of the submenu for changing the
thread tension values. Only visible when
the electric thread tension control is
activated
Cut length
N3 - Selection of buttonhole cut length
from 6 – 65 mm
- The setting is dependent of the buttonhole
number.
Speed
N4 - Selection of sewing speed for the buttonhole
to be sewn from von 200 - 4000 RPM.
The setting is dependent of the buttonhole
number.
- If the set sewing speed is less than the soft
start speed a cautionary warning is
displayed and the soft start is switched off.
- The high speed that is here selectable can
be set in the technician level.
Soft start
N5 Soft start switch on and off
- Number of soft start stitches and their
sewing speed can be preset in the
technician level.
Daily quantity counter
N6 The daily quantity counter counts the number
of sewn buttonholes.
- By pressing the “OK”- key twice, the daily
quantity counter will be reset to zero.
Hook thread counter
N7 Display of the current hook thread counter
state (when active) and selection of the
submenu for the changing of the initial value
and for the switching on and off of the hook
thread counter.
Repair mode
N8 Repair mode.
20