DURKOPP ADLER 540-100-1, Manual Complete

Page: 133 / 234

15
.
Select the menu item “ machine ” using the
p p
and
q q
keys
and confirm by pressing “
OK
".
Calibrating the electronic thread tension
– Check the mechanical basic setting at the magnet and
adjust it if necessary .
– The distance between the mobile cone and the solid
base must me 0,3 mm .
The distance is set with the flat nut on the tension pin .
The nut is locked by a small set screw which is located
in the tension pin .
– Switch on the machine.
– . Press button F and enter code 25483 .
– –
Display the Technician menu.
– –
–
Select the menu item "cal. tension" and press " OK " .
–
Select the menu item "100 gr" and press " OK " .
–
Enter the value for 100 gr an press " OK " .
–
Select the menu item "200 gr" and press " OK "
–
Enter the value for 200 gr an press " OK " .
–
If no measuring instrument for the thread tension is
available, enter the values which are notated on the rear
side of the tension plate.
1