DURKOPP ADLER 540-100-1, Manual Complete, Page: 147 / 234

1
5.3 Parameter programming mode
Buttonhole number
P1
1 … 50
Selection of the buttonhole number
Cut length
P2
6.0 … 65.0 mm
Speed
P3
200 … 4000 RPM
Dependent on buttonhole
Buttonhole seam
parameter
P4 Select the submenu for the selection of
buttonhole seam parameters
Starting variants
P5
A,B,C,D
Selection of the sewing start variants
Upper bartack
parameter
P6 Select the submenu to adjust the upper
bartack
Lower bartack
parameter
P7 Select the submenu to adjust the lower
bartack
2x seams
P8
ON / OFF
Switching on/off of the double-stitching of the
whole buttonhole (the buttonhole is sewn
twice).
Knitwear sewing
mode
P9
ON / OFF
Switching the knitwear sewing mode on or off
Basting stitches
P10* Selection of the submenu for the setting of the
number of the basting stitches and the display
of the characteristics
Zigzag seams
P11* Selection of the submenu for the setting of a
second zigzag seam and the display of the
characteristics
Cutting
P12* Cutting during the last cycle
Cutting during the cycle before the last one
Cutting during both cycles
Copying from
P13 0 … 50 The buttonhole data of the chosen buttonhole
number is copied into the currently active
buttonhole.
*) Those programs are only visible, if the P9 (Knitwear sewing mode) is switched on.
29
M ú
ê M
úú