Digital Equipment ChannelWorks, Network Installer Manual, Page: 43 / 90

Set-Up and First Steps 3-11
Figure 3-8 Read NVRAM Window
Verifying The ChannelWorks Bridge Parameters
Table 3-1 is a list of the ChannelWorks Bridge operating parameters. Common param-
eters are underlined and must be set correctly and exactly the same in all bridges on the
network in order for any of the bridges to boot and operate properly.
Note: Level One and Level Two users cannot modify the bridge’s transmit and receive fre-
quencies.
Verify that you have a list of the ChannelWorks Bridge parameters to check the param-
eter values against. Refer to “Appendix B” for an example of the Pre-Installation
Checklist. Use the LCS to verify current parameters or modify the parameters that you
can access.
If the common parameters of the ChannelWorks Bridge do not match your list, stop the
installation procedure. If access to verify any of the parameters is denied to you, stop
the installation procedure. If access to modify any of the Level Two parameters is
denied to you, stop the installation procedure.