Dialogic 1000Series, User Manual

Page: 211 / 326

Dialogic
®
1000 and 2000 Media Gateway Series User’s Guide 211
Routing Table
Figure 28 is a screen shot of the Device Selection configuration Web page:
Figure 28. Device Selection Configuration Web Page
Outbound Destination - Specifies the network to which the request is to be routed:
– VoIP = Route to the VoIP network.
–
TDM = Route to the TDM network.
–
Blocked = Request is not routed. The inbound request will be immediately rejected.
Host Group - Name of VoIP Host Group to which the request is to be routed.
Note: This selection box is only present when the Outbound Destination is set to VoIP.
Trunk Group - Specifies the name of TDM Trunk Group to which the request is to be routed.
Note: This selection box is only present when the Outbound Destination is set to TDM.
Route Method - Specifies the method used for routing requests:
–
Redirect = Requests are redirected to the destination, which means that the gateway does
not bridge the two networks. Valid only when routing from/to the same network (ex. VoIP-
>VoIP, TDM->TDM).
– Bridged = Requests are bridged through the gateway between the inbound and outbound
network.
Note: This selection box is only present when the Outbound Destination is set to TDM.
CPID Manipulation
CPID Manipulation defines rules for how Calling Number, Calling Name, Called Number, Called
Name, Redirect Number, and Redirect Name appear in the destination call. Typically, the calling
and called numbers from the incoming call are simply passed through to the outgoing call.
However, there are cases where it is desirable to alter either or both of these numbers. A CPID
Manipulation rule is applied to all calls routed via the Routing Table. Each of the rules applies a
formula using the incoming CPID information as inputs to determine the outgoing call's CPID.