Dialogic 1000Series, User Manual

Page: 114 / 326

114 Dialogic
®
1000 and 2000 Media Gateway Series User’s Guide
Parameter Reference
3.8.2.3 Wait for Dial Tone after Flash Hook
Description: Indicate if the gateway should wait for dial tone after flash hook.
Allowed Values:
• Yes = Gateway will wait for dial tone after a Flash Hook as a confirmation that the switch
recognized the event.
• No = Gateway does not expect the switch to create dial tone after a Flash Hook.
Default Value = Yes
INI File Parameter Name = telDialToneExpAfterFlashHook
3.8.2.4 Delay After Flash-Hook
Description: Specifies the duration (in milliseconds) to delay after a Flash Hook if a dial tone
confirmation is not expected.
Note: This parameter can only be changed in the configuration file. It is not accessible through the Web
interface.
Allowed Values: 100 to 10000 milliseconds
Default Value = 2000 milliseconds
INI File Parameter Name = telFlashHookNoDialToneDelayMs
3.8.2.5 Incoming Rings Before Answer
Description: - Specifies the number of ring bursts that must be present at the DMG2000 before the
call is presented to the IP destination as a new call.
Allowed Values: 1 to 100
Default Value = 1
INI File Parameter Name = telIncomRing
3.8.2.6 Ringing Timeout
Description: - Specifies the number of milliseconds of non-ringing that will signal that an
incoming call has gone away.
Allowed Values: 100 to 10000 milliseconds
Default Value = 6000 milliseconds
INI File Parameter Name = telRingOffMs