Dialogic 1000Series, User Manual

Page: 59 / 326

Dialogic
®
1000 and 2000 Media Gateway Series User’s Guide 59
Parameter Reference
Telnet Server Enabled
Description: Defines whether the Telnet Server is enabled. Disable the Telnet Server to prevent
any Telnet connections to the Media Gateway.
Allowed Values:
• Yes
• No
Default Value = Yes
INI File Parameter Name = telnetEnabled
Note: Unit requires a restart if this parameter value is changed.
3.2.6 Serial Ports Group
The Serial ports subgroup includes the following parameter:
• Maintenance Port Enabled
Maintenance Port Enabled
Description: Defines whether the Maintenance port is enabled. Disable to prevent any
Maintenance messages from being transmitted by the port. If disabled, the Maintenance port will
show only boot messages before the port is disabled.
Note: If the Web interface and Maintenance port are both turned off, the only way to re-enable the
Maintenance port is to re-enable the port through booter as follows:
1. Cycle power on unit.
2. Break into the booter by typing “pimg” immediately when prompted with the following: “Type
pimg to stop auto-boot...” A direct Serial connect between the Gateway and PC should be used.
Note: There is 2 seconds to start typing and 5 seconds to finish.
3. At the BOOT> prompt, type “pwd” command to login and then enter password.
4. At the BOOT-admin> prompt, type “reset” command.
5. The Gateway now resets to factory defaults; one of which is Serial port enabled. The Gateway
will then continue to start the Gateway application.
Caution: IP address is also reset so the user must restore it before the Web interface will work.
Allowed Values:
• Yes
• No
Default Value = Yes
INI File Parameter Name = maintPortEnabled
Note: Unit requires a restart if this parameter value is changed.