DHS Systems TM 95263 00, Operation And Maintenance Manual

Page: 82 / 132

DHS Systems, LLC TM 95236-00 0006
0006-20
No rights are conveyed except as indicated in the legend on the cover of this document.
SHUTDOWN AND PREPARE FOR TRANSPORT
The following procedures details powering down and storing the AVCS (MINI) system.
NOTE
The AVCS (MINI) maintains all operational information and instructions on a flash memory card.
There are no shut down procedures necessary for the system software.
If the AVCS (MINI) is supplying power to a projector, ensure that the projector has been shut
down IAW manufacturers’ instructions prior to turning off the AVCS (MINI) System.
Power Down AVCS (MINI) System
1. Power down all peripheral equipment connected to the AVCS (MINI) IAW the appropriate Technical Manual.
RGB 1 RGB 2
VIDEOOUT
RG B 1 RGB 3
RGB 2
RGB 4
CV 1
CV 2
GND.
11 0 AC ONLY
INPUT ONLY
EXT ERNAL
DEVICE
CTL . IP RESET
CT L . LAN T OUCH PANEL
PO TS L INE
PR OTECTI ON
L INE A
SPEAKER
AUDIOOUT
CONTROL
VIDEOIN
AUDIOIN
WEIGHTRANGE
80-100 LBS.
HA RD IG G
FAULT
PRESEN T
LINE
O K
isobar
LINE 1
LINE 2 MI C 2
MIC 1
1
Figure 21. Main Power Supply Switch.
NOTE
Do not turn off the RGB spectrum 4-Window Processor Power Switch on the front of the AVCS
system.
2. Set the Main Power supply ON/OFF switch (Figure 21, Item 1), located on the top right rear of the AVCS
(MINI), to ‘OFF’.
Disassemble and Store the Ancillary Equipment Included with the AVCS (MINI)
The AVCS (MINI) is stored in two transit cases. The first case houses the AVCS (MINI) System and the second
case houses all ancillary equipment.
1. Retrieve the ancillary equipment transport case from its storage position.
2. Open the cover of ancillary equipment transport case.