DHS Systems TM 95263 00, Operation And Maintenance Manual

Page: 62 / 132

DHS Systems, LLC TM 95236-00 0005
0005-14
No rights are conveyed except as indicated in the legend on the cover of this document.
Speaker Adjustment
The Speaker should already be out of the Ancillary Case and partially setup (see SETUP AND CONNECT
AUDIO OUTPUT DEVICES).
1. On the speaker’s rear panel, set the LINE IN LEVEL (LIL) to the desired level by rotating the LIL dial clockwise.
The recommended level is 75% of Max. If not using a directly connected microphone, set the microphone level to
MIN to prevent additional noise.
2. If using a direct connection Microphone, set the MICROPHONE LEVEL to 50% by rotating the MICROPHONE
LEVEL dial clockwise.
3. Activate the Microphone and speak into it. Adjust the MICROPHONE LEVEL to desired level.
NOTE
Extremely important to have the correct voltage selected. Damage to the equipment may occur if
incorrectly selected. Power input is fused. Fuse door is located below AC power input connector.
Figure 11. Speaker Setup.
END OF TASK
END OF WORK PACKAGE