DHS Systems TM 95263 00, Operation And Maintenance Manual

Page: 109 / 132

DHS Systems, LLC TM 95236-00 0013
0013-1
No rights are conveyed except as indicated in the legend on the cover of this document.
OPERATOR MAINTENANCE PROCEDURES
AVCS (MINI)
SERVICE UPON RECEIPT
INITIAL SETUP:
Personnel Required: References
Two WP 00
GENERAL
The following procedures are required to be performed by the operator in order to prepare the AVCS and its
contents for use.
SITE SELECTION
To ensure minimal problems with set-up of the AVCS (MINI) and good operation of equipment being used in
conjunction with it, ensure area is:
Dry and environmentally controlled
Protected area to run cables from AVSC to ancillary equipment
AVCS REQUIREMENTS
The AVCS (MINI) requires 110 VAC of surge protected power to operate.
SERVICE UPON RECEIPT
Inspect each system component for damage incurred during shipment. If any damage is visible, notify supervisor.
Report the damage on SF361, Transportation Discrepancy Report. Check the equipment against the packing slip
to see if the shipment is complete. Report all discrepancies in accordance with applicable service instructions.
Once all covers are removed, inspect the system and each piece of ancillary equipment. Inspect all connectors,
cables, and loose pieces of equipment located in the boxes. Refer to PMCS before placing the equipment into
service.
INSTALLATION INSTRUCTIONS
The AVCS requires some assembly to place into operation. To set up the AVCS (MINI) refer to WP 0005 of this
TM for setup and power up procedures.
PRELIMINARY SERVICING OF EQUIPMENT
WARNING
When working on the AVCS (MINI), do not operate the equipment is the case or equipment
shows signs of moisture or water intrusion. Electrical shock can cause personnel injury or
death and may result in damage to equipment.
Do not apply power in the system is not properly grounded to the power source. Electrical
shock can cause personnel injury or death and may result in damage to equipment.
The AVCS (MINI) does not require a preliminary service. Daily checks are addressed in the
PMCS tables located in WP 0015 of this TM.
END OF WORK PACKAGE