DHS Systems TM 95263 00, Operation And Maintenance Manual

Page: 61 / 132

DHS Systems, LLC TM 95236-00 0005
0005-13
No rights are conveyed except as indicated in the legend on the cover of this document.
Connect AVCS (MINI) Power Cable and Ground Lead
WARNING
GROUND THE EQUIPMENT
Before connecting primary power cables, connect grounding cable from ground lug on power control
box to earth ground. Do not remove grounding cable until signal cables and primary power cables
have been disconnected and Genset has been shut down.
Refer to “Earth Grounding and Bonding Pamphlet”, CECOM TR-98-6, Oct 1998 for more detailed
information on grounding procedures.
Note that a ground lead is not provided with the AVCS (MINI).
1. Attach one end of ground lead to ground lug (Figure 11, Item 1) on rear of AVCS.
2. Connect opposite end of ground wire to suitable grounding point.
3. Locate the AVCS (MINI) power supply cable from the Ancillary Equipment Case.
2. Identify the power connector (Figure 11, Item 2) on the Left Bottom Rear of the AVCS (MINI) and remove the dust
cover.
3. Insert the female connector on the power cord into the AVCS (MINI) power connector.
4. Plug the 110VAC power connector into a 110VAC power source.
RGB1 RGB2
VIDEO OUT
RGB1 RGB3
RGB2 RGB4
CV1
CV2
GND.
110ACONLY
INPUT ONLY
EXTERNAL
DEVICE
CTL. IPRESET
CTL.LAN TOUCHPANEL POTSLINE
P ROTECTION
LINEA SPEAKER
AUDIO OUT CONT ROL
VIDEOIN
AUDIO IN
WEIGHT RANGE
80-100 LBS.
HARDI GG
FAUL T PRE SENT
LINE
OK
isobar
LINE1
LINE2 MIC 2
MIC1
GND.
110 AC ONLY
INPUT ONLY
1
2
Figure 11. Connect AVCS (MINI) System Power Cable and Ground Lead.
END OF TASK