Delta CP2000 Series, User Manual

Page: 461 / 868

Chapter 12 Description of Parameter Settings

CP2000
12.1-06-13
requirement. When the fault occurs, the corresponding terminals activate. Convert the binary
value to decimal value before you enter the value for Pr.06-23–Pr.06-26).
Fault Code
bit0 bit1 bit2 bit3 bit4 bit5 bit6
current Volt. OL SYS FBK EXI CE
0: No fault
1: Over-current during acceleration (ocA)
●
2: Over-current during deceleration (ocd)
●
3: Over-current during constant speed (ocn)
●
4: Ground fault (GFF)
●
5: IGBT short-circuit (occ)
●
6: Over-current at stop (ocS)
●
7: Over-voltage during acceleration (ovA)
●
8: Over-voltage during deceleration (ovd)
●
9: Over-voltage during constant speed (ovn)
●
10: Over-voltage at stop (ovS)
●
11: Low-voltage during acceleration (LvA)
●
12: Low-voltage during deceleration (Lvd)
●
13: Low-voltage during constant speed (Lvn)
●
14: Low-voltage at stop (LvS )
●
15: Phase loss protection (OrP)
●
16: IGBT over-heat (oH1)
●
17: Capacitance over-heat (oH2)
●
18: tH1o (TH1 open)
●
19: tH2o (TH2 open)
●
21: Drive over-load (oL)
●
22: Electronics thermal relay protection 1 (EoL1)
●
23: Electronics thermal relay protection 2 (EoL2)
●
24: Motor PTC overheat (oH3) (PTC / PT100)
●
26: Over-torque 1 (ot1)
●
27: Over-torque 2 (ot2)
●
28: Low current (uC)
●
30: Memory write-in error (cF1)
●
31: Memory read-out error (cF2)
●
33: U-phase current detection error (cd1)
●
34: V-phase current detection error (cd2)
●
35: W-phase current detection error (cd3)
●
36: Clamp current detection error (Hd0)
●
37: Over-current detection error (Hd1)
●
38: Over-voltage detection error (Hd2)
●
39: IGBT short-circuit detection error (Hd3)
●
40: Auto tuning error (AUE)
●
41: PID feedback loss (AFE)
●
48: Analog current input loss (ACE)
●
49: External fault input (EF)
●
50: Emergency stop (EF1)
●
51: External Base Block (bb)
●
52: Password error (Pcod)
●