Delta CP2000 Series, User Manual

Page: 397 / 868

Chapter 12 Description of Parameter Settings

CP2000
12.1-02-8
Settings Functions Descriptions
68 Disable Motor 8
69
Preheating Command
ON: if the preheating function is open and drive is in STOP status,
the preheating function is executed; until the contact status
changes to OFF, or the drive status turns to RUN and stops the
preheating function. Refer to Pr.02-72–02-73 for detail.

UP/DOWN Key Mode
Default: 0
Settings 0: Up / Down by the acceleration or deceleration time
1: Up / Down constant speed (Pr.02-10)

Constant speed, Acceleration or Deceleration Speed of the UP/DOWN Key
Default: 0.001
Settings 0.001–1.000 Hz/ms
 Use when the multi-function input terminals are set to 19, 20 (UP / DOWN command). The
frequency increases or decreases according to Pr.02-09 and Pr.02-10.
 When Pr.02-09 is set to 0: the increasing or decreasing frequency command (F) operates
according to the setting for acceleration or deceleration time (refer to Pr.01-12–Pr.01-19)
 When Pr.02-09 is set to 1: the increasing / decreasing frequency command (F) operates
according to the setting for Pr.02-10 (0.01–1.00 Hz/ms).

Multi-function Input Response Time
Default: 0.005
Settings 0.000–30.000 sec.
 Sets the response time of the digital input terminals FWD, REV and MI1–MI8.
 This function is to delay and confirm the digital input terminal signal. The time for delay is also the