Appendix D How to Use PLC Function
|
D-38
Revision June 2008, 04EE, SW--PW V1.11/CTL V2.11
Explanations:
When the RST command is driven, motion of its specific device is as follows:
Device
Status
Y, M
Coil and contact will be set to “OFF”.
T, C
Present values of the timer or counter
will be set to 0, and the coil and contact
will be set to “OFF.”
D
The content value will be set to 0.
Program Example:
Ladder diagram:
Command code:
Operation:
LD
X0
Load contact A of X0
X0
Y5
RST
RST
Y5
Clear contact Y5
Mnemonic Function
TMR 16-bit
timer
T-K T0~T15,
K0~K32,767
Operand
T-D T0~T15,
D0~D29
Explanations:
When TMR command is executed, the specific coil of timer is ON and timer will start to count. When
the setting value of timer is attained (counting value >= setting value), the contact will be as following:
NO(Normally Open) contact
Open collector
NC(Normally Closed) contact
Close collector
Program Example:
Ladder diagram:
Command code:
Operation:
LD
X0
Load contact A of X0 T5 timer
X0
T5
TMR
K1000
TMR
T5 K1000
Setting is K1000
Summary of Contents for AC Motor Drive VFD-E
