Dell Force10 Z9000, Reference Manual

Page: 727 / 1483

LineSpeed 1000 Mbit, Mode full duplex
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 00:06:14
Queueing strategy: fifo
Input 791 packets, 62913 bytes, 775 multicast
Received 0 errors, 0 discarded
Output 21 packets, 3300 bytes, 20 multicast
Output 0 errors, 0 invalid protocol
Time since last interface status change: 00:06:0
3
Example
(OpenFlow
instance)
FTOS#show interfaces vlan 6
Vlan 6 is down, line protocol is down
Address is 00:01:e8:8a:e1:8c, Current address is
00:01:e8:8a:e1:8c
Interface index is 1107525638
of-instance: 2
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed auto
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 00:05:12
Queueing strategy: fifo
Time since last interface status change: 00:05:12
Related
Commands
show interfaces configured – displays any interface with a non-default configuration.
show interfaces linecard – displays information on all interfaces on a specific line card.
show interfaces phy
show interfaces rate
– displays information of either rate limiting or rate policing on the
interface.
show interfaces switchport – displays Layer 2 information about the interfaces.
show inventory (C-Series and E-Series) – displays the chassis type, components (including
media), FTOS version including hardware identification numbers, and configured protocols.
show inventory (S-Series and Z-Series) – displays the S-Series and Z-Series switch types,
components (including media), FTOS version including hardware identification numbers, and
configured protocols.
show ip interface – displays Layer 3 information about the interfaces.
show linecard – displays the line card(s) status.
show range – displays all interfaces configured using the interface range command.
727