Dell Force10 Z9000, Reference Manual

Page: 769 / 1483

23
IPv4 Routing
The basic IPv4 commands are supported by FTOS on all Dell Force10 E-Series, C-Series, S-Series or Z-Series platforms.
arp
Use address resolution protocol (ARP) to associate an IP address with a MAC address in the switch.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax arp vrf { vrf name } ip-address mac-address interface
To remove an ARP address, use the
no arp ip-address
command.
Parameters
vrf name E-Series Only: Enter the virtual routing and forwarding (VRF) process
identifier to tie the static route to the VRF process.
ip-address Enter an IP address in dotted decimal format.
mac-address Enter a MAC address in nnnn.nnnn.nnnn format.
interface (OPTIONAL) Enter any of the following keywords and slot/port or
number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For the Management interface, enter the keyword
ManagementEthernet
followed by the slot/port
information. The slot range is 0 to 1 and the port range is 0.
• For a Port Channel interface, enter the keywords
port-
channel
followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword
sonet
followed by
the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
followed by the slot/port information.
Defaults Not configured.
Command Modes CONFIGURATION
769