Dell Force10 Z9000, Reference Manual

Page: 786 / 1483

ip domain-lookup
Enable dynamic host-name to address resolution (that is, DNS).
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax p domain-lookup
To disable DNS lookup, use the
no ip domain-lookup
command.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Usage
Information
To fully enable DNS, also specify one or more domain name servers with the
ip name-
server
command.
FTOS does not support sending DNS queries over a VLAN. DNS queries are sent out all other
interfaces, including the Management port.
To view current bindings, use the
show hosts
command.
Related
Commands
ip name-server – specifies a DNS server.
show hosts – Views the current bindings.
ip domain-name
Configure one domain name for the switch.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip domain-name name
To remove the domain name, use the
no ip domain-name
command.
Parameters
name Enter one domain name to be used to complete unqualified names
(that is, incomplete domain names that cannot be resolved).
Defaults Not configured.
Command Modes CONFIGURATION
786