Dell blcwxfg - Latitude XT - Core 2 Solo 1.06 GHz, User Manual

Page: 169 / 248

Adding and Replacing Parts
169
CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions located in the
Product Information Guide
.
NOTICE:
To prevent damage to the system board, remove the main battery before
you service the Tablet-PC.
Removing a Memory Module
1 Follow the procedures in "Before You Begin" on page 155.
2
Remove the memory and Mini-Card cover. See "Removing the Memory
and Mini-Card Cover" on page 168.
NOTE:
Memory modules purchased from Dell are covered under your Tablet-PC
warranty.
NOTICE:
To prevent damage to the memory module connector, do not use tools to
spread the memory-module securing clips.
3 Ground yourself by touching one of the metal connectors on the back of
the Tablet-PC.
4 Use your fingertips to carefully spread apart the securing clips on each end
of the memory module connector until the module pops up.
5 Remove the module from the connector and set aside.
Installing a Memory Module
1 Ground yourself by touching one of the metal connectors on the back of
the Tablet-PC.
NOTE:
If the memory module is not installed properly, the Tablet-PC may not boot
properly. No error message indicates this failure.
2
Align the notch in the module edge connector with the tab in the
connector slot.
3 Slide the module firmly into the slot at a 45-degree angle, and rotate the
module down until it clicks into place. If you do not feel the click, remove
the module and reinstall it.
book.book Page 169 Tuesday, May 13, 2008 5:03 PM