Dell BigIron RX-16, Installation Manual

Page: 67 / 240

BigIron RX Installation Guide 55
53-1001811-01
Installing a BigIron RX-16 switch
2
CAUTION
Carefully follow the mechanical guides on each side of the power supply slot and make sure the
power supply is properly inserted in the guides. Never insert the power supply upside down.
4. After the power supply is fully inserted, push the power supply front panel toward the back of
the chassis. This action causes the power supply connector to latch into the backplane
connector.
5. For information about connecting power to the chassis, refer to “Connecting AC power to a
BigIron RX-16 chassis” below.
6. For information about powering on the system, refer to “Powering-on the power source” on
page 79.
Connecting AC power to a BigIron RX-16 chassis
AC power is supplied through an AC power cord that is installed at the rear of the BigIron RX-16
chassis.
1. At the rear of the BigIron RX-16 chassis, locate the power receptacle where the power supplies
have been installed.
2. Lift the cord-retainer and connect a Brocade-supplied AC power cord to the power supply.
3. Snap the cord-retainer over the power plug to hold it in place.
FIGURE 37 Connecting a power cord to the power supply in a BigIron RX-16 chassis
1 Lift handle 4 Ground point
2 Cord retainer 5 Lift handles
3 Power cord
1
2
3
4
5