Dell BigIron RX-16, Installation Manual

Page: 69 / 240

BigIron RX Installation Guide 57
53-1001811-01
Installing a BigIron RX-32 switch
2
FIGURE 39 Crimping the power supply wire in the lug
4. Re-attach the transparent cover over the power supply lugs that was removed in Step 1.
5. Connect the wire to your DC power source, making sure to connect the -48V cable to the
negative terminal on the power supply and the 0V cable to the positive terminal as marked on
the power supply.
Final steps
Follow the steps listed below to complete the installation:
•
“Attaching a management station”
•
“Powering-on the power source”
•
“Verifying proper operation”
Installing a BigIron RX-32 switch
This section describes the following tasks:
•
“Preparing the installation site”
•
“Unpacking a BigIron RX-32 switch”
•
“Installing a BigIron RX-32 chassis in a rack”
•
“Installing BigIron RX-32 modules”
•
“BigIron RX-32 cable routing”
•
“Installing power supplies in a BigIron RX-32 chassis”
•
“Connecting AC power to a BigIron RX-32 chassis”
•
“Final steps”
Preparing the installation site
Cabling infrastructure
Ensure that the proper cabling is installed in the site.
For information on cabling, refer to “BigIron RX-32 cable routing” on page 67, “Installing power
supplies in a BigIron RX-32 chassis” on page 75, “Attaching a management station” on page 77,
and “Connecting a BigIron RX Series switch” on page 105.
1 #8 AWG power supply wire
1