Dell BigIron RX-16, Installation Manual

Page: 89 / 240

BigIron RX Installation Guide 77
53-1001811-01
Attaching a management station
2
6. Gently pull the release latch on the power supply front panel upward and toward the top of the
power supply front panel. This action locks the power supply in place.
7. For information about connecting power to the chassis, refer to “Connecting AC power to a
BigIron RX-32 chassis” on page 77.
8. For information about powering on the system, refer to “Powering-on the power source” on
page 79.
Connecting AC power to a BigIron RX-32 chassis
AC power is supplied through an AC power cord that is installed in the front of each power supply in
the BigIron RX-32 chassis.
1. At the front of the BigIron RX-32 chassis, locate the power receptacle on the front panel of
each power supply that has been installed. Refer to Figure 55 .
2. Lift the cord retainer and connect a Brocade-supplied AC power cord to the power supply.
3. Snap the cord retainer over the power plug to hold it in place.
FIGURE 55
BigIron RX-32 power supply receptacle and cord retainer
Final steps
You should complete the final step in the order in which they are listed:
•
“Attaching a management station”
•
“Powering-on the power source”
•
“Verifying proper operation”
Attaching a management station
You can manage the BigIron RX Series system in the following ways:
•
You can connect a PC or terminal to the management module’s serial (Console) port for a
direct connection. From this interface, you can configure the
10BaseT/100BaseTX/1000BaseTX Ethernet (management) port with an IP address and either
Telnet or SSH. This enables you to manage the device through the
10BaseT/100BaseTX/1000BaseTX Ethernet (management) port using either Telnet or SSH.
1 Cord retainer 2 Power receptacle
AC OK
DC OK
ALM
1
2