Pilot's Operating Handbook
Section 8
Handling, servicing and maintenance
Edition 0 - March 05, 2019
Rev. 3
Page 8.9.7
6)
Pull up and hold L.H. and R.H. rings (2) and turn knobs (8) by 90
°
in
order to insert locks (3) into rail (5) apertures.
7)
Make sure the seat is correctly locked on rails (5).
8)
Tilt seat forward, hold it and slip strap (9) around the locking control
hinge pin. Screw quick links (7).
9)
Open the floor hatch and remove clip from holder located under floor
panel and connect heating system harness (26). Clip connectors on
the holder located on the seat structure.
10) Tilt the seat rearward and lock it using seat tilting handle (1).
11) Fold up the backrest and lock it using backrest tilting handle (6).
12) Slide properly the carpet under the seat.
13) Remove protective covers.
G - Reconditioning
1)
Make sure the work area is clean and free from debris.
2)
Determine weight and balance - refer to section 6.
3 --
Additional configurations
▲
WARNING
▲
Removed seats can only be installed at their original location.
Rear seat (L.H. or R.H.) is the only one which can be installed in
cabin axis, on both central rails – refer to section 7.
▲
●
NOTE
●
Many combinations of accommodations are authorized with seats (rear and
intermediate) by pilot or service centers and cabinet(s) by service centers only.
However, the pilot must ensure that he/she gets all necessary authorizations
from his/her regulatory authority.
●
●
NOTE
●
To remove or install these elements, use paragraph 1 or 2 – refer to table 1.
●
PIM - DO NOT USE FOR FLIGHT OPERATIONS
