Pilot's Operating Handbook
Section 8
Handling, servicing and maintenance
Edition 0 - March 05, 2019
Rev. 0
Page 8.9.2
b)
Unlock backrest using backrest tilting handle (6) and fold it
forward.
●
NOTE
●
For the R.H. rear seat, backrest tilting handle is located behind backrest.
●
c)
Unlock seat using seat tilting handle (1) and tilt it forward.
▲
CAUTION
▲
Make sure to disconnect the seat heating system before the removal of
the seat to prevent harness damage.
▲
d)
Disconnect heating system harness, and clip the loose
connector to the holder located on the seat structure.
e)
Clear the carpet from under the seat to facilitate moving in rails.
f)
Open the floor hatch and clip the second loose connector to the
holder located under floor panel. Close the floor hatch.
g)
Hold the seat in tilted position and unscrew quick links (7) of
strap (9) located under L.H. seatpan.
●
NOTE
●
This operation is specific to L.H. seat.
●
h)
Pull up and hold L.H. and R.H. rings (2), and turn knobs (8) by 90
°
in order to release and keep locks (3) in up position.
i)
Move the seat in the rails to line up pads (4) with rail (5) apertures.
j)
Remove the seat.
●
NOTE
●
Ensure proper storage of strap (9) with L.H. rear seat to avoid loosing part.
●
D - Removal of intermediate seats - see figures 8.9.2 and 8.9.3
1)
To remove intermediate seats, perform the following operations
a)
Install protective covers.
b)
Pull backrest bottom upholstery (25) to remove it.
PIM - DO NOT USE FOR FLIGHT OPERATIONS
