Pilot's Operating Handbook
Section 8
Handling, servicing and maintenance
Edition 0 - March 05, 2019
Rev. 3
Page 8.9.6
C - Cabin comfort - see figure 8.9.3
1)
Remove blanking plugs (32) from their storage bag and install them on
holes located forward the large door - see figure 8.9.3 detail B.
2)
Remove blanking device assy (33) from the hot air outlet, located
forward the large door, and store it into storage bag - see figure 8.9.3
detail A.
3)
Remove blanking plugs (31) located in line with card table - see
figure 8.9.3 detail D, and install them on holes located in line with R.H.
front side window - see figure 8.9.3 detail C.
●
NOTE
●
Should long term changes be made to cabin configuration (4 / 6 seats), cabin
upholstery blanking device and plug arrangements will need to be reconfigured
in order to optimize the temperature conditioning system.
Subject changes should preferably be performed at a recognized service
center.
●
D - Installation of cabinet
●
NOTE
●
This operation must be carried out by a service center.
●
E - Installation of intermediate seats
1)
Install intermediate seats – refer to paragraph 1 G.
2)
If removed, install the baggage compartment partition net.
3)
If removed, install cabin central carpet.
F - Installation of rear seats - see figure 8.9.1
1)
Make sure the work area is clean and free from debris.
2)
Clear the carpet from seat area to facilitate moving in rails.
3)
Check that knobs (8) maintain locks (3) in up position.
4)
Position the seat, fold it forward, refer to detail B, and insert pads (4)
into rail (5) apertures.
5)
Move the seat so that locks (3) are in front of the color mark made on rail
bottom.
PIM - DO NOT USE FOR FLIGHT OPERATIONS
