Pilot's Operating Handbook
Section 8
Handling, servicing and maintenance
Edition 0 - March 05, 2019
Rev. 0
Page 8.9.3
▲
CAUTION
▲
Make sure to disconnect the seat heating system before the removal of
the seat to prevent harness damage.
▲
c)
Disconnect heating system harness and clip the loose connector
to the holder located on the seat structure.
d)
Clear the carpet from under the seat to facilitate moving in rails.
e)
Open the floor hatch and clip the second loose connector to the
holder located under floor panel. Close the floor hatch.
f)
Pull up locking handle (21) located under the pan, on the seat
rear side, to unlock it.
g)
Move the seat in the rails to line up pads (23) with rail (24)
apertures.
h)
Remove the seat.
i)
Install backrest bottom upholstery (25).
▲
CAUTION
▲
In order to prevent deflectors damage, it is necessary to remove them.
▲
2)
Remove deflector (34) maintained with Velcro-type strap.
3)
If necessary, remove the cabin central carpet.
●
NOTE
●
If one of two cargo nets must be installed, it is necessary to use the carpet with
appropriate cuttings.
●
E - Removal of a cabinet
●
NOTE
●
This operation must be carried out by a service center.
●
F - Cabin comfort - see figure 8.9.3
1)
Blank off the hot air outlet, located forward the large door, with blanking
device assy (33) stored in storage bag - see figure 8.9.3 detail A.
2)
Remove blanking plugs (32) located forward the large door and store
them into storage bag - see figure 8.9.3 detail B.
PIM - DO NOT USE FOR FLIGHT OPERATIONS
