Pilot's Operating Handbook
Section 3
Emergency procedures
EASA Approved
Edition 0 - March 05, 2019
Rev. 3
Page 3.12.39
>> With HomeSafe emergency function (Post-MOD70-0650-34A)
HomeSafe deactivation
▲
WARNING
▲
HomeSafe deactivation must be performed by a pilot :
- fully capable of flying the airplane,
- fully aware of all the actions the pilot will have to perform to
reconfigure the airplane (the initial flight plan in the FMS is lost,
the landing gear and flaps positions may not agree with
LANDING GEAR and FLAPS levers positions).
▲
▲
CAUTION
▲
HomeSafe deactivation is not recommended on final approach.
▲
1 -
AP/TRIM DISC push-button
Press twice
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
AT and AP also disengage
▲
CAUTION
▲
MFD reconfiguration can take up to 1 minute. During this time, engine
instruments and CAS messages can be displayed on PFD by using
DISPLAY BACKUP.
▲
2 -
L.H. DISPLAY BACKUP push-button
Press
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
3 -
LVL push-button
Press
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4 -
Before using VHFs, set appropriate frequency and used VHF.
5 -
Inform ATC that the pilot is back and flying the airplane, and ask for altimeter
setting.
Inform that the pilot must reenter the flight plan in the FMS
6 -
Altimeter setting
Re-adjust
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
If necessary
If
AC CONF MISMATCH
is ON :
7 -
Perform procedure
AC CONF MISMATCH
. . . . . . . . . . . . . . . . . . . . .
Refer to chapter 3.7
End of procedure.
PIM - DO NOT USE FOR FLIGHT OPERATIONS