DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
Page | 311
enable pvid auto_assign
Purpose
Enable/disable auto assignment of pvid.
Syntax
enable|disable pvid auto_assign
Description
The command enables the auto-assign of PVID.
If “auto-assign PVID” is disabled, PVID only be changed by PVID configuration
(user changes explicitly). The VLAN configuration will not automatically change
PVID.
If “Auto-assign PVID” is enabled, PVID will be possibly changed by PVID or VLAN
configuration. When user configures a port to VLAN
X
’s untagged membership,
this port’s PVID will be updated with VLAN X. In the form of VLAN list
command, PVID is updated with last item of VLAN list. When user removes a port
from the untagged membership of the PVID’s VLAN, the port’s PVID will be
assigned with “default VLAN”.
The default setting is enabled.
Parameters
None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To enable the auto-assign PVID:
DGS-3700-12:5#enable pvid auto_assign
Command: enable pvid auto_assign
Success.
DGS-3700-12:5#
show pvid auto_assign
Purpose
Show PVID auto-assigment state.
Syntax
show pvid auto_assign
Description
This command is used to display PVID auto-assignment state.
Parameters
None.
Restrictions
None.
Example usage:
To display PVID auto-assignment state:
DGS-3700-12:5#show pvid auto_assign
Command: show pvid auto_assign
PVID Auto-assignment: Enabled
DGS-3700-12:5#
config gvrp
Purpose
Used to configure the timer’s value of GVRP and MAC address of GVRP’s PDU of
NNI port in Q-in-Q mode.
Syntax
config gvrp [timer [join | leave | leaveall] < value 100-100000> | nni_bpdu_addr
[dot1d | dot1ad]]
Description
This command is used to set the GVRP timer’s value and GVRP’s PDU MAC address
of NNI port in Q-in-Q mode. The default value for Join time is
200
milliseconds;
