DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
Page | 165
T
IME AND
SNTP
C
OMMANDS
Back to Section Header
The Simple Network Time Protocol (SNTP) (an adaptation of the Network Time Protocol (NTP)) commands
in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
C
OMMAND
P
ARAMETERS
config sntp
{primary <ipaddr> | secondary <ipaddr> | poll-interval <int 30-99999>}
show sntp
enable sntp
disable sntp
config time
<date ddmthyyyy > <time hh:mm:ss >
config time_zone
{operator [+ | -] | hour <gmt_hour 0-13> | min <minute 0-59>}
config dst
[disable | repeating {s_week <start_week 1-4,last> | s_day <start_day sun-sat> |
s_mth <start_mth 1-12> | s_time <start_time hh:mm> | e_week <end_week 1-
4,last> | e-day <end_day sun-sat> | e_mth <end_mth 1-12> | e_time <end_time
hh:mm> | offset [30 | 60 | 90 | 120]} | annual {s_date <start_date 1-31> |
s_mth <start_mth 1-12> | s_time <start_time hh:mm> | e_date <end_date 1-
31> | e_mth <end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60 | 90
| 120]}]
show time
Each command is listed, in detail, in the following sections.
config sntp
Purpose
Used to setup SNTP service.
Syntax
config sntp {primary <ipaddr> | secondary <ipaddr> | poll-interval <int 30-
99999>}
Description
This command is used to configure SNTP service from an SNTP server. SNTP must
be enabled for this command to function (See enable sntp).
Parameters
primary
−
This is the primary server from which the SNTP information will be taken.
<ipaddr>
−
The IP address of the primary server.
secondary
−
This is the secondary server the SNTP information will be taken from in
the event the primary server is unavailable.
<ipaddr>
−
The IP address for the secondary server.
poll-interval <int 30-99999>
−
This is the interval between requests for updated
SNTP information. The polling interval ranges from 30 to 99,999 seconds.
Restrictions
Only Administrator and Operator-level users can issue this command. SNTP service
must be enabled for this command to function (
enable sntp
).
Example usage:
To configure SNTP settings:
