DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
Page | 30
DGS-3700-12G:5#config temperature log state enable
Command: config temperature log state enable
Success.
DGS-3700-12G:5#
config temperature threshold
Purpose
To configure the warning temperature high threshold or low threshold.
Syntax
config temperature threshold {high <temperature> | low <temperature>}
Description
This command is used to configure the warning temperature high threshold or low
threshold. When temperature is above the high threshold or below the low
threshold, SW will send alarm traps.
Parameters
high
- Specify the high threshold value. The high threshold must bigger than the low
threshold..
low
- Specify the low threshold value.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To configure a warming temperature threshold high of 80:
DGS-3700-12G:5#config temperature threshold high 80
Command: config temperature threshold high 80
Success.
DGS-3700-12G:5#
show serial_port
Purpose
Used to display the current console port settings.
Syntax
show serial_port
Description
This command is used to display the current console port settings.
Parameters
None.
Restrictions
None.
Example usage:
To display the serial port settings:
DGS-3700-12:5#show serial_port
Command: show serial_port
Baud Rate : 115200
Data Bits : 8
Parity Bits : None
Stop Bits : 1
Auto-Logout : 10 mins
DGS-3700-12:5#
config serial_port
Purpose
Used to configure the serial bit rate that will be used to communicate with the
management host and the auto logout time for idle connections.
