DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
Page | 511
O
BJECT
A
CCESS
M
ETHOD
(OAM)
S
ECTION
11
Table of Contents
Next Section
Previous Section
CFM
EXTENSION
(ITU-T
Y.1731)
Back to Section Header
The CFM Extension commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
C
OMMAND
P
ARAMETERS
config cfm ais
md <string 22> ma <string 22> mepid <int 1-8191> { period [ 1sec |
1min] | level <int 0-7> | state [ enable | disable] }(1)
config cfm lock
md <string 22> ma <string 22> mepid <int 1-8191> { period [1sec |
1min] | level <int 0-7>| state [enable | disable]}(1)
cfm lock
md <string 22> ma <string 22> mepid <int 1-8191> remote_mepid <int
1-8191> action [start | stop]
cfm loopback
<macaddr> [mepname <string 32> | mepid <int 1-8191> md <string 22>
ma <string 22>] {num <int 1-65535> | [length <int 0-1500> | pattern
<string 1500>] | pdu_priority <int 0-7>}
show cfm
{ [ md <string 22> {ma <string 22> {mepid <int 1-8191>}} | mepname
<string 32>]}
show cfm fault
{md <string 22> {ma <string 22>}}
Each command is listed, in detail, in the following sections.
config cfm ais
Purpose
Used to configure parameters of AIS function.
Syntax
config cfm ais md <string 22> ma <string 22> mepid <int 1-8191> { period [ 1sec
| 1min] | level <int 0-7> | state [ enable | disable] }(1)
Description
This command is used to configure the parameters of AIS function on a MEP.
The default state is disabled.
The default period is 1 second.
The default client MD level is MD level at which the most immediate client layer
MIPs and MEPs exist.
Note: This default client MD level is not a fixed value. It may change when creating
or deleting higher level MD and MA on the device.
When the most immediate client layer MIPs and MEPs do not exist, the default client
MD level cannot be calculated. If the default client MD level cannot be calculated
and user doesn’t designate a client level, the AIS and LCK PDU cannot be
transmitted.
Parameters
md
–Maintenance domain name.
ma
–Maintenance Association name.
mepid
–The MEP ID in the MD which sends AIS frame.
state
– Specifies the MEP AIS state
enable
- AIS function enabled.
