DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
Page | 515
DGS-3700-12:5#show cfm
Command: show cfm
Name : mep1
MEPID : 1
Port : 1
Direction : Inward
CFM Port State : Enabled
MAC Address : XX-XX-XX-XX-XX-XX
MEP State : Enabled
CCM State : Enabled
PDU Priority : 7
Fault Alarm : Mac_status
Alarm Time : 2 second(s)
Alarm Reset Time : 10 second(s)
Highest Fault : Some Remote MEP Down
AIS State : Enabled
AIS Period : 1 Second
AIS Client Level : 5
AIS Status : Detected
LCK State : Enabled
LCK Period : 1 Minute
LCK Client Level : 5
LCK Status : Not Detected
Out-of-Sequence CCMs : 0 received
Cross-connect CCMs : 0 received
Error CCMs : 0 received
Port Status CCMs : 0 received
If Status CCMs : 0 received
CCMs transmitted : 1234
In-order LBRs : 0 received
Out-of-order LBRs : 0 received
Next LTM Trans ID : 27
Unexpected LTRs : 0 received
LBMs Transmitted : 0
AIS PDUs : 10 received
AIS PDUs Transmitted : 0
LCK PDUs : 0 received
LCK PDUs Transmitted : 0
Remote
MEPID MAC Address Status RDI PortSt IfSt LCK Detect Time
------ ----------- ------ --- ------- -------- ------ -------------------
2 XX-..-XX-XX OK Yes Blocked Up Yes 2008-01-01 12:00:00
3 XX-..-XX-XX IDLE No No No Yes 2008-01-01 12:00:00
4 XX-..-XX-XX OK No Up Down No 2008-01-01 12:00:00
8 XX-..-XX-XX START No Up Up No 2008-01-01 12:00:00
12 XX-..-XX-XX FAILED No Up Up No 2008-01-01 12:00:00
8 XX-..-XX-XX OK No Up Up No 2008-01-01 12:00:00
DGS-3700-12:5#
show cfm fault
Purpose
This command is used to show fault MEPs.
Syntax
show cfm fault {md <string 22> {ma <string 22>}}
Description
This command is used to display all the fault conditions detected by the MEPs
contained in the specified MA or MD. This display provides the overview of fault
status by MEPs.
