DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
Page | 181
To set the trap state:
DGS-3700-12:5#config erps trap enable
Command: config erps trap enable
Success.
DGS-3700-12:5#
show erps
Purpose
To display ERPS information.
Syntax
show erps {raps_vlan <vlanid> {sub_ring}}
Description
This command is used to display ERPS configuration and operation information. The
port state of the ring port may be as "Forwarding", "Blocking", "Signal Fail".
"Forwarding" indicates that traffic is able to be forwarded. "Blocking" indicates
that traffic is blocked by ERPS and a signal failure is not detected on the port.
"Signal Fail" indicates that a signal failure is detected on the port and traffic is
blocked by ERPS.
Parameters
vlanid -
Specifies the R-APS VLAN.
sub_ring
- Display sub-ring configuration information.
Restrictions
None.
Example usage:
To display ERPS information:
