DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
336
Figure 9-54 IP-MAC-Port Binding Settings Window
The fields that can be configured in
IP-MAC-Port Binding Trap Settings
are described below:
Parameter
Description
Trap State
Select the enable or disable the IP-MAC-Port binding option’s trap state.
Click the
Apply
button to accept the changes made.
The fields that can be configured in
IP-MAC-Port Binding Port Settings
are described below:
Parameter
Description
Unit
Select the Switch unit that will be used for this configuration here.
From Port - To Port
Select the appropriate port range used for the configuration here.
Mode
Select the mode of access control that will be used here. Options to choose
from are
Disabled
,
Strict
, and
Loose
. When a port is enabled for IMPB strict-
mode access control, a host can only access the port after the host sends ARP
or IP packets and the ARP packet or IP packet sent by the host passes the
binding check. To pass the binding check, the source IP address, source MAC
address, VLAN ID, and arrival port number must match any of the entries
defined by either the IP source guard static binding entry or the DHCP
snooping learned dynamic binding entry. When a port is enabled for IMPB
loose-mode access control, a host will be denied to access the port after the
host sends ARP or IP packets and the ARP packet or IP packet sent by the
host does not pass the binding check. To pass the binding check, the source IP
address, source MAC address, VLAN ID, and arrival port must match any of the
entries defined by either the IP source guard static binding entry or the DHCP
snooping learned dynamic binding entry.
Click the
Apply
button to accept the changes made.
IP-MAC-Port Binding Blocked Entry
This window is used to view and clear the IP-MAC-Port binding blocked entry table.
To view the following window, click
Security > IMPB > IPv4 > Advanced Settings > IP-MAC-Port Binding Blocked
Entry
, as shown below:
Summary of Contents for DGS-3130 Series
Page 1: ......
