DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
331
Parameter
Description
addresses are dropped. Sender IP addresses are checked in all ARP requests
and responses, and target IP addresses are checked only in ARP responses.
Click the
Apply
button to accept the changes made.
The fields that can be configured in
ARP Inspection Filter
are described below:
Parameter
Description
ARP Access List Name
Enter the ARP access list name used here. This name can be up to 32
characters long.
VID List
Enter the VLAN ID list used here.
Static ACL
Select whether to use a static ACL or not here by either selecting
Yes
or
No
.
Click the
Add
button to add a new entry based on the information entered.
Click the
Delete
button to remove an entry based on the information entered.
Enter a page number and click the
Go
button to navigate to a specific page when multiple pages exist.
ARP Inspection Port Settings
This window is used to display and configure the ARP inspection port settings.
To view the following window, click
Security > IMPB > IPv4 > Dynamic ARP Inspection > ARP Inspection Port
Settings
, as shown below:
Figure 9-47 ARP Inspection Port Settings Window
The fields that can be configured are described below:
Parameter
Description
Unit
Select the Switch unit that will be used for this configuration here.
From Port - To Port
Select the appropriate port range used for the configuration here.
Rate Limit
Enter the rate limit value here. This value must be between 1 and 150 packets
per seconds.
Burst Interval
Enter the burst interval value here. This value must be between 1 and 15. Tick
the
None
option to disable the option.
Trust State
Select to enable or disable the trust state here.
Click the
Apply
button to accept the changes made.
Summary of Contents for DGS-3130 Series
Page 1: ......
