Modular L3 Ethernet Switch User’s Guide
86
2. Enable GVRP per port to participate in GVRP.
3. Specify the maximum number of GVRP VLANs after reset.
4. Reset the device to receive the new maximum number of GVRP VLANs set.
To increase the number of Maximum GVRP VLANs and to reconfigure the GVRP protocol:
1. Specify a new value of the maximum number of GVRP VLANs after reset.
2. Reset the device.
3. Check that the new value is displayed in the
Max GVRP VLANs field.
For more information about configuring the Maximum number of GVRP VLANs and Maximum
number of GVRP VLANs after Reset fields, see the Device Tuning section later in this manual.
Consideration Concerning STP And GVRP Operation
The circulation of GARP/GVRP registration information follows through the Bridged LANs
active topology and it is assumed that the STP protocol is established and maintained.
Note:
When operating in the STP per device mode with the Must belong to VLAN parameter set
to True, STP reacts to GVRP enabled on a port as if a VLAN was created on this port
GARP Timers Control
The
GARP Port Timers Control Window
contains information about timers for every bridged
port.
To display the GARP Timers Control window:
Select
>
Device
>
GARP > GARP Timers Control
. The
GARP Port Timers Control
window
displays.
Summary of Contents for DES-6300
Page 40: ...Modular L3 Ethernet Switch User s Guide 31 ...
Page 298: ......