Modular L3 Ethernet Switch User’s Guide
130
1. Display
the
IP Router Interface Parameters Edit
window.
2. Press
the
OSPF Parameters
button. The
OSPF Interface Table
Edit
window opens:
Figure 6- 91. OSPF Interface Table Edit
window
The
OSPF Interface Table
Edit
window displays the following fields:
IP Address –
The IP address of this OSPF interface.
Area ID –
The IP address of the area.
lf Type
–
The interface type, such as Broadcast.
Admin.
Status –
The administrative status of the OSPF in the router. Enabled
means that the OSPF process is active on at least one interface. Disabled means the
process is not active on any interface.
Priority –
The priority of this interface. The value 0 means that this router is not
eligible to become the designated router on the current network. If more than one
router has the same priority, the router ID is used.
Hello Interval (sec) –
The amount of seconds between Hello packets. All routers
attached to a common network must have the same Hello Interval.
Time Before Declare Router Dead (sec) –
The number of seconds a router's
Hello packets have not been detected, before the router's neighbors declare the
router to be down. The value must be multiple of the Hello Interval value. All
routers attached to a common network must have a value specified for this
parameter.
lf State
–
The OSPF interface state:
•
Down
–
The OSPF interface is down.
•
Loopback
–
The OSPF interface is in the Loopback state.
Summary of Contents for DES-6300
Page 40: ...Modular L3 Ethernet Switch User s Guide 31 ...
Page 298: ......